Tuesday, 27 September 2011

How to close a pool for the season

!±8± How to close a pool for the season

The nights start with, a little 'cooler (40 degrees or less), and pool owners recognize him as the first sign that the season is ready to change. The day to reduce enough to swim and later, until they are regularly numbered in the days that are too cold to swim hot. At some point there is no denying, the swimming season is over!

When it is time to close the pool ready, take the time to do it properly to avoid problems during the winter months and to avoid delaysOpening of the pool when warm weather returns. About three days to a week before closing the pool, the preparation begins. Adjust the chemical balance of water in the following areas:

pH: 7.2 to 7.6

Alkalinity: 80-120 ppm

Calcium Hardness: 180-220ppm

Reduce the filtering time, after more than a week

Once this is done, shock the pool, following the instructions on the package. If the chlorine content is 1.0 to 3.0, in the winter algaecide can be added and will not interferethe effectiveness of algaecide.

To avoid damage from freezing and / or snow, these elements should be removed from a pool and stored for the winter:

Skimmer baskets (all pools)

Wall mount (all pools)

Detergents (all pools)

Stairs (land)

Bridges and rails (top)

Solar panels (all pools)

Some pool covers require the water level is lowered. Check the manufacturer's recommendations cover pool. Use a submersible pump orpump low water level if necessary.

Remove all plugs from devices such as pumps, heating and chlorine. Completely drain all the equipment. If necessary, turn off appliances so there is no water to freeze and damage the pool equipment. If possible, remove the pump and the closed shop. DE filter grids and cartridges must be removed and cleaned. It is recommended to lubricate the o-rings, and gas heaters with cast iron plug is a good idea to lubricateTopics.

The pool is clean and clear as possible. If you really must keep the pool should not have much to be flown over and vacuum the pool.

For in-ground pools if you do not turn off lines, add antifreeze, according to package directions. Once the first frost lines for sure, install anchors. For above ground pools, the lines can be separated. Put air cushions in a large above ground swimming pool will help protect the finish.

If 'Swimming pool is clear and the water is clean and the level of desired chemical, it is time to cover them. A well-fitting lid is important for a closed swimming pool.


How to close a pool for the season

Delta Windemere Faucet Discounted

Thursday, 22 September 2011

Swimming Pool Heat Pump - What are the benefits?

!±8± Swimming Pool Heat Pump - What are the benefits?

Swimming pool heat pumps are a great way for your swimming pool to a comfortable temperature to continue to swim even during the cooler nights in spring and autumn. These heaters do not generate heat itself, but also act as a heat exchanger, the collection of thermal energy from the environment. A fan draws air through an evaporator with the refrigerant absorbs heat and is filled with a gas. A compressor increases the heat of the gas through a condenser coil, which passes the transferHeat the pool water circulating.

The water is heated again in the pool and increases the temperature of the water in your pool. So that you can use the pool most of the year, so your investment is paying much better. The most important thing is to choose the right size heater for your pool.

Heaters for pools are evaluated on the basis of their production of heat in BTUs. The device eliminates BTU plus, get the faster the water temperature in your pool. Due to the largeVariety of sizes and shapes of pools and different climate zones in which there are swimming pools, the BTU rating is necessary to vary the water temperature comfortable. A professional can be the size of the unit, you must be determined from the surface of your pool, the water temperature (the difference between the average air temperature and water temperature). It is also possible to determine this number yourself using the tools available online. Once you know how many BTUneed to heat your pool, you can begin to compare different models of heat pumps pool.

When you start to look different pool heat pump, you always want a heater that rated higher than the minimum number required to collect previously. The larger the heater you buy, the faster the heat of your pool. This means that the heater will run less frequently, and often is longer than a smaller model.

If you choose a pool heatPump must be installed after the filter system be introduced, but most of all chemicals (including chlorine) are used. This ensures that the heat pump will not be exposed to chemicals too strong. You probably need a professional to install heat pumps - not just to ensure it is done correctly, can also help you avoid accidents. Swimming pool heat pumps are an ideal way to make your pool to be used almost year round, depending on where you live.


Swimming Pool Heat Pump - What are the benefits?

Bolens Trimmer Parts Buy Online


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。







Sponsor Links